Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > Power Back Door cannot be Closed Using the Power Back Door Closer Switch

for Preparation Click here


DESCRIPTION

When the power back door cannot be closed using the power back door closer switch, one of the following may be malfunctioning: 1) power back door closer switch circuit, or 2) power back door drive unit (power back door ECU).

WIRING DIAGRAM


B165217E05


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Check the Data List to determine if the power back door closer switch functions properly.

    Back door (Power back door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PBD Close SW
    Power back door closer switch signal / ON or OFF
    ON: Power back door closer switch ON
    OFF: Power back door closer switch OFF
    -

    OK:
    The power back door closer switch functions as specified in the normal condition.



NG
Go to step 2
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)  

2.INSPECT POWER BACK DOOR CLOSER SWITCH


    B165201E02
  1. Remove the power back door closer switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Pushed (ON)
    Below 1 Ω
    1 - 2
    Free (OFF)
    10 kΩ or higher



NG
REPLACE POWER BACK DOOR CLOSER SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (POWER BACK DOOR CLOSER SWITCH - POWER BACK DOOR DRIVE UNIT)


    B165212E02
  1. Disconnect the T10 switch connector.

  1. Disconnect the O15 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T10-1 - O15-4 (DS1)
    Always
    Below 1 Ω
    T10-2 - Body ground
    Always
    Below 1 Ω
    T10-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)