Home › BODY ELECTRICAL › OTHER SYSTEM › INVERTER RELAY

INVERTER RELAY > INSPECTION

for Preparation Click here



1. INSPECT INVERTER RELAY
  1. Remove the inverter relay.



    B016200
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the inverter relay.