Home › ENGINE › 3MZ-FE FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE VAPOR PRESSURE SENSOR ASSEMBLY


    A108214E02
  1. Remove the cover.

  1. Remove the tube joint clip, and pull out the vapor pressure sensor.



2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A182856E01
  1. Disconnect the fuel sender gauge connector (A).

  1. Unlock the fuel sender gauge, then slide and remove it (B).



3. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    A107259E02
  1. Disconnect the fuel pump connector (A).

  1. Using a screwdriver with its tip wrapped with tape, disengage the 4 snap claws from claw holes, and pull out the fuel suction plate.

    NOTICE:
    Do not damage the fuel suction support.



4. REMOVE FUEL PUMP HARNESS


    A107254E04
  1. Disconnect the connector (A).

  1. Using a screwdriver, pry out the fuel pump harness (B).



5. REMOVE NO. 2 FUEL SUCTION SUPPORT


    A182857
  1. Using a screwdriver with its tip wrapped with tape, disengage the 4 snap claws from the claw holes, and remove the fuel suction support.

    NOTICE:
    Do not damage the fuel suction support.



6. REMOVE FUEL PUMP CUSHION RUBBER


    A182858
  1. Remove the fuel pump cushion rubber from the fuel pump.



7. REMOVE FUEL PUMP


    A182859E01
  1. Pull out the fuel pump from the fuel tank fuel filter.



8. REMOVE FUEL PUMP FILTER


    A079497
  1. Using a screwdriver, pry out the clip.

  1. Pull out the fuel pump filter from the fuel pump.