Home › ENGINE › 3MZ-FE ENGINE MECHANICAL › TIMING BELT

TIMING BELT > INSPECTION

for Preparation Click here



1. INSPECT TIMING BELT

NOTICE:
  1. Do not bend, twist or turn the timing belt inside out.
  2. Do not allow the timing belt to come into contact with oil, water or steam.
  3. Do not utilize timing belt tension when installing or removing the mounting bolt of the camshaft timing pulley.
Check the belt for any defects, as shown in the illustration. Also, check the points below.



    EM03336E01
  1. If there is premature parting:

    1. Check for proper installation.

  1. If the belt teeth are cracked or damaged, check if either camshaft is locked.

  1. If there is noticeable wear or cracks on the belt face, check if there are nicks on the side of the idler pulley lock and water pump.

  1. If there is wear or damage to only one side of the belt, check the belt guide and the alignment of each pulley.

  1. If there is noticeable wear on the belt teeth:

    1. Check the timing cover for damage.
    2. Check for foreign objects on the pulley teeth. If there is any trouble in the belt condition, replace the timing belt.