Home › BRAKE › BRAKE CONTROL › ABS MOTOR RELAY

ABS MOTOR RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SKID CONTROL NO.2 RELAY
  1. Remove the ABS MTR1 relay and the ABS MTR2 relay.



    C144829E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    Battery positive voltage is applied between terminals 1 and 2
    Below 1 Ω