Home › BRAKE › BRAKE CONTROL › ABS MAIN RELAY

ABS MAIN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SKID CONTROL RELAY
  1. Remove the ABS No. 1 relay and ABS No. 2 relay.



    C143433E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    Battery positive voltage is applied between terminals 1 and 2
    Below 1 Ω