Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

HYBRID CONTROL SYSTEM > OPERATION HISTORY DATA

for Preparation Click here



OPERATION HISTORY DATA

HINT:
The hybrid vehicle control ECU records the special operations performed by the driver and the number of abnormal conditions that have been input to the ECU as operation history data.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG) and turn the Techstream on.

  3. Select the following menu items: Powertrain / Hybrid Control / Data List.

  4. Select the menu to view the number of inappropriate operations or controls that have been effected.

    HINT:
    1. LATEST OPER: Among the past occurrences, the number of inappropriate operations or controls that have been effected during the most recent 1 trip detection.
    2. LATEST TRIP: The number of trips after the occurrence of LATEST OPER.
    3. BEF LATST OPER: The number of occurrences during the trip previous to the LATEST OPER.
    4. BEF LATST TRIP: The number of trips after the occurrence of BEF LATST OPER.


    Operation history data: 
    Tester Display
    Count Condition
    Shift Gear before READY
    Shift lever moved with READY light blinking
    N Range Control in Half Shift
    Shift position cannot be determined
    N Range Control by Busy Shift
    N position control effected due to frequent shifting operation
    Step Accelerator in N Range
    Accelerator pedal depressed in N position
    Auxiliary Battery Low
    Auxiliary battery voltage below 9.5 V
    HV ECU Intermittent Problems
    Instantaneous open circuit at IGSW terminal of hybrid vehicle control ECU
    MG2 Temp High
    MG2 temperature rose above 334°F (168°C)
    MG1 Temp High
    MG1 temperature rose above 334°F (168°C)
    MG2 (Motor) Inv Temp High
    Motor inverter temperature rose above 248°F (120°C)
    MG1 (Generator) Inv Temp High
    Generator inverter temperature rose above 248°F (124°C)
    Main Battery Low Voltage
    Battery state of charge dropped below 30%
    Resister Over Heat
    System main resistor overheated
    Rear Motor Temp High
    MGR temperature rose above 334°F (168°C)
    Rear Motor Inv Temp High
    Rear motor inverter temperature rose above 212°F (100°C)
    Coolant Heating
    Inverter coolant forecast temperature rose above 149°F (65°C)
    Converter Heating
    Boost converter temperature rose above 232°F (111°C)
    Shift P in Running
    Shifted to P while moving
    Shift Backward Direction
    Shifted to R while moving forward or to D or B while moving in reverse
    Prevention Control of Staying
    Engine speed stays in resonance frequency band
    Accelerator and Brake Depressing
    Both accelerator and brake pedals depressed