REMOVAL
| Symbol meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut Location for Supply Parts |
| *A | LH | - | - |
| *B | RH | - | - |
INSTALLATION
| Symbol meaning | |
|---|---|
|
Spot Weld |
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
When welding *a, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
Before installing a new part, apply body sealer.
Apply body sealer evenly about 5 mm (0.20 in.) from the flange, avoiding any oozing.
Apply body sealer evenly, about 3 to 4 mm (0.12 to 0.16 in.) in diameter.
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *b in the illustration.
Apply enough adhesive to the panels.
After welding, apply foamed sealing material to the corresponding parts. (See the painting / coating)
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *A | LH | *B | w/ Blind Spot Monitor System |
| *1 | QUARTER PANEL | *2 | SIDE PANEL REAR END PATCH |
| *c | mm (in.) | - | - |
| *3 | QUARTER PANEL RETAINER | *4 | FUEL FILLER OPENING LID ASSEMBLY |
| *5 | RIVETS | - | - |
| *C | RH | *D | w/ Blind Spot Monitor System |
| *6 | QUARTER PANEL | *7 | SIDE PANEL REAR END PATCH |
| *d | mm (in.) | - | - |