Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › from 2016.11
BM3160E _V1 General _021869 INTRODUCTION _0112095 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed
Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)
Pre-collision system
Parking Assist Monitor System
Panoramic View Monitor System
Back door lock*1 Power door lock control system
Servo motor initialization Air Conditioning System (for Automatic Air Conditioning System)
Servo motor initialization Air Conditioning System (for Manual Air Conditioning System)
Reset back door close position*2 Power Back Door System

*1: w/o Power Back Door System

*2: w/ Power Back Door System


NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 second*1 or 120 seconds*2 before disconnecting the cable from the negative (-) battery terminal. (for Radio and Display Type)

*1: w/ Toyota Link Function

*2: w/o Toyota Link Function

·

After the engine switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation Receiver Type)