Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › ENGINE UNIT › 2013.12–2016.11
NM3160E _51 Engine / Hybrid System _020738 2GR-FE ENGINE MECHANICAL _0105515 ENGINE UNIT DE DETAILS F

2GR-FE ENGINE MECHANICAL  ENGINE UNIT  DETAILS  CYLINDER BLOCK  


CONSTRUCTION


a.

The cylinder block sub-assembly is made of aluminum alloy, so it is lightweight.


b.

The cylinder block sub-assembly has a bank angle of 60°, a bank offset of 36.6 mm (1.441 in.) and a bore pitch of 105.5 mm (4.15 in.), resulting in a compact block (length and width) for its displacement.


c.

Installation bosses for the 2 knock control sensors are located on the inside of the left and right banks.

W100007
5.292,1.458 5.292,0.323 5.292,0.323 4.042,0.323 true 6.292,0.281 5.469,0.281 5.469,0.281 5.469,1.76 true 4.781,3.167 6.083,3.448 1.302,0.281 10 false 105.5 mm (4.15 in.) 3.969,2.656 4.667,3.01 0.698,0.354 10 false 36.6 mm (1.441 in.) 1.188,0.563 1.531,0.729 0.344,0.167 10 false 60° 3.875,0.229 4.083,0.396 0.208,0.167 10 false *a 6.323,0.208 6.531,0.375 0.208,0.167 10 false *a
*a Knock Control Sensor Boss - -



d.

Water passages are provided between the cylinder bores. By allowing the engine coolant to flow between the cylinder bores, this construction enables the temperature of the cylinder walls to be kept uniform.

W100008
5.365,1.833 5.365,3.094 true 5.292,3.125 5.469,3.292 0.177,0.167 10 *a
*a Water Passage - -



e.

A compact block has been achieved by producing the thin cast-iron liners and cylinder block sub-assembly as a unit. It is not possible to rebore a block which uses this type of liner.


f.

The liners are a spiny-type, which have been manufactured so that their casting exterior forms large irregular surfaces in order to enhance the adhesion between the liners and the aluminum cylinder block sub-assembly. The enhanced adhesion helps heat dissipation, resulting in a lower overall temperature and reduced heat deformation of the cylinder bores.

W100009
3.833,2.448 4.083,2.448 4.083,2.448 4.563,1.927 true 5.135,0.427 4.844,0.427 4.844,0.427 4.563,1.167 true 5.042,1.979 5.531,1.979 true 2.708,1.156 2.875,1.333 0.167,0.177 10 A 3.406,0.979 3.573,1.156 0.167,0.177 10 A 3.656,2.385 3.844,2.563 0.188,0.177 10 *2 5.177,0.354 5.406,0.563 0.229,0.208 10 *1 5.583,1.917 5.771,2.115 0.188,0.198 10 *a 4.875,2.802 5.063,3.021 0.188,0.219 10 *b
*1 Cylinder Block Sub-assembly *2 Liner
*a Irregularly Shaped Outer Casting Surface of Liner *b A-A Cross Section