Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM
NM3160E _54 Brake _020756 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0105904 BRAKE CONTROL SYSTEM CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  CONTROL  STEERING COOPERATIVE CONTROL  


SYSTEM CONTROL


a.

Steering cooperative control performs coordinated control using both VSC and EPS. By integrating these active safety functions, excellent driving stability and maneuverability are secured.


b.

If the vehicle loses stability due to wheel slippage, this function performs brake control by applying brake pressure to each individual wheel while at the same time, the EPS provides steering torque assist control to facilitate the driver's steering maneuver.

X115992
2.688,0.313 5.896,0.51 3.208,0.198 10 false Steering Sensor 2.688,0.656 5.896,0.854 3.208,0.198 10 false Yawrate Sensor 2.688,1.031 5.896,1.229 3.208,0.198 10 false Master Cylinder Pressure Sensor 0.927,2.385 2.271,3.146 1.344,0.76 10 false Actual Locus of Travel (Front Wheel Skid Tendency) 2.052,3.74 3.073,4.583 1.021,0.844 10 false Locus of Travel Based on the Target Yaw Rate 4.094,2.573 4.635,2.792 0.542,0.219 10 false ECM 5.229,2.063 6.25,2.49 1.021,0.427 10 false Power Steering ECU Assembly 3.719,3.354 4.833,3.708 1.115,0.354 10 false Engine Output Control Command 5.031,3.344 6.438,4.083 1.406,0.74 10 false Steering Torque Assist Control Command 4.26,4.323 6.021,4.698 1.76,0.375 10 false Control Volume Calculation 1.375,5.438 2.469,5.719 1.094,0.281 10 false Brake Control 3.677,5.021 4.906,5.813 1.229,0.792 10 false 4 Wheel Independent Brake Control Command 5.063,5.042 6.625,5.885 1.563,0.844 10 false Vehicle Driving Condition Detection and Calculation 3.104,1.51 6.313,1.708 3.208,0.198 10 false Various Sensor Signals 4.677,6.333 7.125,6.531 2.448,0.198 10 false Skid Control ECU


c.

When braking on a split friction road, the vehicle tends to deflect toward the higher friction side due to the difference between the brake force on the left and right sides. In this state, the power steering ECU receives command signals from the skid control ECU. Based on these signals, the power steering ECU operates the EPS motor to reduce the effect of this brake force difference on either side, assisting the driver in making corrective steering operations.

X115138
4.167,1.708 4.49,1.708 true 4.521,1.635 4.833,1.833 0.313,0.198 10 false *a
*a Spin Moment - -
V100135

Braking Force
V100136

Anti Spin Moment
V100137

Steering Torque Assist - -
V100145

Slippery Surface - -



d.

When accelerating on a split friction road, the vehicle tends to deflect toward the lower friction side due to the drive force difference between the left and right sides. In this state, the skid control ECU performs brake control of the drive wheel on the low friction side (TRC function) and transmits command signals to the power steering ECU. Based on these signals, the power steering ECU operates the EPS motor to reduce the effect of this drive force difference on either side, assisting the driver in making corrective steering operations. As a result, ideal drive force control and vehicle stability is ensured.

X115139
4.135,1.688 4.458,1.688 true 4.49,1.615 4.802,1.813 0.313,0.198 10 false *a
*a Spin Moment - -
V100135

Driving Force
V100136

Anti Spin Moment
V100137

Steering Torque Assist - -
V100145

Slippery Surface - -



e.

When understeer (front wheel skid) is detected, engine output is limited and brake control is performed based on the amount of understeer tendency. Accordingly, a moment of force is generated in the vehicle turning direction to limit the understeer tendency.


f.

Steering torque assist is also provided to warn the driver of understeer.


g.

If the driver turns the steering wheel excessively, steering torque assist is provided to prevent excessive steering input.


h.

When oversteer (rear wheel skid) is detected, brake force is applied to mainly the outer wheels based on the amount of oversteer tendency. Accordingly, an anti-spin moment is generated to limit the oversteer tendency.

X115140
0,0 0,0 false
V100135

Braking Force
V100136

Moment of force to restrict front wheel skid
V100137

Steering Torque Assist (to prevent excessive steering input)
V100138

Steering Torque Assist (to warn driver of understeer)



i.

In this state, the power steering ECU receives command signals from the skid control ECU. Based on these signals, the power steering ECU operates the EPS motor to compensate for the oversteer tendency, assisting the driver in making corrective steering operations.

X115141
0,0 0,0 false
V100135

Braking Force
V100136

Anti Spin Moment
V100137

Steering Torque Assist - -