Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MONITOR SYSTEM › 2013.12–2016.11
NM3160E _56 Audio / Visual / Telematics _020715 PARK ASSIST / MONITORING _0106528 MONITOR SYSTEM CO CONTROL F

PARK ASSIST / MONITORING  MONITOR SYSTEM  CONTROL  MONITOR CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Television Camera Assembly Transmits a video signal of the area behind the vehicle to the radio and display receiver assembly.
Radio and Display Receiver Assembly Displays images of the area behind the vehicle sent from the television camera assembly using the multi-display.
Park/Neutral Position Switch Assembly Sends an R shift position signal to the BACK UP LP relay.
Engine Room Relay Block and Junction Block Assembly
·

BACK UP LP Relay


Sends an R shift position signal to the radio and display receiver assembly.


SYSTEM CONTROL


a.

This system operates when both the following conditions have been met:

·

The ignition switch is ON.

·

The shift lever is in R.




FUNCTION


a.

Area Displayed on Screen

i.

Objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.


ii.

The television camera assembly uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.

Y143235

NOTICE:

The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the television camera assembly is limited. The television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.




b.

Warning Message

i.

A warning message appears at the bottom of the screen under the following condition. The warning message appears in the same language that has been selected by the language selector of the multi-display.

Message Appearing at Bottom of Screen
Warning Message Condition
Check surroundings for safety. This message always appears during system operation.




FAIL-SAFE


a.

The table below indicates fail-safe operation when a malfunction is detected:

Malfunctioning Parts Detection Item Function
Television Camera Assembly Television camera assembly malfunction signal is detected. System stops signal reception and displays a dark screen.
Radio and Display Receiver Assembly Malfunction of radio and display receiver assembly Stops system operation