SYSTEM CONTROL
The sliding roof system has the following functions:
| Function | Outline |
|---|---|
|
*1: Customizable parameters can be configured through customize settings. For details, refer to the Repair Manual. *2: Models with smart entry and start system *3: Models without smart entry and start system |
|
| Manual Open-and-close | Opens and closes the sliding roof when the open switch or close switch is pressed for less than 0.3 seconds. The sliding roof stops as soon as the switch is released. |
| One-touch Auto Open | ·
Opens the sliding roof up to the fully opened position when the open switch is pressed for 0.3 seconds or more. ·
To reduce wind noise, this function stops opening the sliding roof at an appropriate stop position. By pressing the open switch once again, the sliding roof can be fully opened. |
| One-touch Auto Close | Fully closes the sliding roof when the close switch is pressed for 0.3 seconds or more. |
| Manual Tilt Up-and-down | Tilts the sliding roof up or down when the up switch or down switch is pressed for less than 0.3 seconds. The sliding roof stops as soon as the switch is released. |
| One-touch Auto Tilt Up-and-down | Fully tilts the sliding roof up or down when the up switch or down switch is pressed for 0.3 seconds or more. |
| Jam Protection | Automatically stops the sliding roof and opens it almost fully if a foreign object gets jammed in the sliding roof during close or tilt down operation. |
| Key Off Operation | Makes it possible to operate the sliding roof for approximately 43 seconds after the ignition switch has been turned from ON to ACC or off, if the driver door or front passenger door is not opened. |
| Key-linked Operation*1 | ·
When the driver door key cylinder is turned and held in the unlock position for 2.5 seconds or more, the sliding roof control ECU activates the sliding roof motor to open the sliding roof while the key cylinder is turned. ·
Similarly, turning and holding the driver door key cylinder in the lock position will cause the sliding roof to close. |
| Transmitter-linked Operation*1 | ·
When the main body ECU (multiplex network body ECU) receives an unlock signal from the electrical key transmitter sub-assembly*2 or door control transmitter assembly*3 continuously for 4 seconds or more via the door control receiver, the sliding roof control ECU opens the sliding roof. ·
Similarly, when the main body ECU (multiplex network body ECU) receives a lock signal from the electrical key transmitter sub-assembly*2 or door control transmitter assembly*3 continuously for 4 seconds or more via the door control receiver, the sliding roof control ECU closes the sliding roof. |
| Sliding Roof Open Warning | If the sliding roof is open when the ignition switch is turned from ON to off and the driver door is opened, a door open warning message will be displayed on the multi-information display for approximately 6.0 seconds, then a sliding roof open warning message will be displayed on the multi-information display, the multi buzzer will sound and the master warning light will blink. |
The sliding roof control ECU memorizes the initial position of the sliding roof. This memory is not cleared if the cable is disconnected from the negative (-) battery terminal. However, initialization is necessary if the sliding roof drive gear sub-assembly is replaced. For details, refer to the Repair Manual.
Jam Protection Function
To control the jam protection function, the sliding roof ECU monitors the amount of movement and judges jamming of the sliding roof based on the pulse signal from Hall IC1 and the movement direction of the sliding roof from the phase difference between the pulses signals of Hall IC1 and Hall IC2.