Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM › from 2016.11
NM3160E _54 Brake _020756 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0105904 BRAKE CONTROL SYSTEM CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  CONTROL  PRE-COLLISION BRAKE  


SYSTEM CONTROL


a.

If the driving support ECU assembly determines that the possibility of a collision is high, the ECU sends the pre-collision brake assist request signal to the skid control ECU. Upon receiving the signal, the skid control ECU switches the brake assist to standby mode. When the driver depresses the brake pedal, the skid control ECU operates the brake assist based on the master cylinder pressure sensor.


b.

If the driving support ECU assembly determines an unavoidable collision, the ECU sends the pre-collision brake request signal to the skid control ECU. The skid control ECU then activates the brake actuator assembly as a pre-collision brake control and decelerates the vehicle. Thus, the system helps to lessen impact in collision.