Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2016.11
NM3160E _57 Power Source / Network _020763 NETWORKING _0106552 CAN COMMUNICATION SYSTEM GE GENERAL F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The Controller Area Network (CAN) is a serial data communication network for real time application. It is a multiplex communication network equipped in a vehicle, and has communication speeds of 500 kbps (HS-CAN) and 250 kbps (MS-CAN), and the ability to detect malfunctions.


b.

The HS-CAN consists of the V bus, bus 2, bus 3 and bus 5.


c.

The MS-CAN consists of the sub bus 1.


d.

The main body ECU (multiplex network body ECU) has a gateway function and is used to transmit data between the bus 2 and sub bus 1.


e.

The communication wire used is a twisted-pair wire. The bus line has a high line (2.5 V to 3.5 V of voltage is applied) and a low line (1.5 V to 2.5 V of voltage is applied).


f.

The terminating resistors for each bus are located as shown in the following table.

Bus Terminating Resistor Location Gateway Function Gateway Destination
CAN V Bus Central Gateway ECU (Network Gateway ECU) Central Gateway ECU (Network Gateway ECU)
·

Bus 2

·

Bus 3

·

Bus 5


CAN Bus 2
·

Combination Meter Assembly

·

ECM


Central Gateway ECU (Network Gateway ECU)
·

V Bus

·

Bus 3

·

Bus 5


Main Body ECU (Multiplex Network Body ECU) Sub Bus 1
CAN Bus 3 Central Gateway ECU (Network Gateway ECU) Central Gateway ECU (Network Gateway ECU)
·

V Bus

·

Bus 2

·

Bus 5


CAN Bus 5
·

Central Gateway ECU (Network Gateway ECU)

·

CAN Junction Terminal


Central Gateway ECU (Network Gateway ECU)
·

V Bus

·

Bus 2

·

Bus 3


CAN Sub Bus 1
·

Main Body ECU (Multiplex Network Body ECU)

·

Multiplex Network Door ECU


Main Body ECU (Multiplex Network Body ECU) Bus 2