Home › Engine / Hybrid System › 2GR-FKS FUEL › FUEL SYSTEM › from 2016.11
NM3160E _51 Engine / Hybrid System _060958 2GR-FKS FUEL _0298833 FUEL SYSTEM DE DETAILS F

2GR-FKS FUEL  FUEL SYSTEM  DETAILS  FUEL INJECTOR (FOR DIRECT INJECTION)  


CONSTRUCTION


a.

A 1-hole type high pressure slit nozzle fuel injector assembly (for direct injection), which has 1 injection hole shaped like a slit, is used.


b.

The use of this fuel injector assembly (for direct injection) causes the fuel to become highly atomized and spread over a wide fan-shaped area. At the same time, the fuel is mixed with a large amount of air and injected into the combustion chamber. As a result, fuel injection dissipation performance is improved to achieve a homogeneous air-fuel mixture, high performance and high engine output.


c.

An O-ring and backup ring* are used in the fuel injector assembly (for direct injection). As a result, the transmission of operation noise from the fuel injector assembly (for direct injection) is reduced to enhance quietness and ensure fastener airtightness.

NOTICE:

*: The backup ring is installed to securely support the rubber O-ring, which is subjected to high pressures. Take care to install the backup ring in the correct direction at the correct installation position.


W130113C01
1.75,0.25 2.083,0.25 2.083,0.25 2.583,0.5 true 3.5,0.333 3.333,0.333 3.333,0.333 2.948,0.625 true 3.5,2.75 3.333,2.75 3.333,2.75 2.896,3.146 true 1.573,0.167 1.802,0.323 0.229,0.156 10 false *1 3.552,0.24 3.781,0.396 0.229,0.156 10 false *2 3.552,2.667 3.802,2.823 0.25,0.156 10 false *3 2.698,3.583 2.948,3.75 0.25,0.167 10 false *a 4.865,2.594 5.094,2.76 0.229,0.167 10 false *b
*1 O-ring *2 Backup Ring
*3 Teflon Sealant - -
*a Fuel Injector Assembly (for Direct Injection) Cross Section *b Injection Hole