Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2013.12–2016.11
RM3160E _56 Audio / Visual / Telematics _019700 AUDIO / VIDEO _0096790 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Display Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E268447
0.969,0.635 1.427,0.833 0.458,0.198 10 false VV+ 1,1.438 1.458,1.635 0.458,0.198 10 false VV- 1.344,0.542 1.802,0.74 0.458,0.198 10 false 6 1.344,1.323 1.802,1.521 0.458,0.198 10 false 11 0.375,2.688 0.833,2.885 0.458,0.198 10 false F74 0.375,2.875 1.708,3.25 1.333,0.375 10 false No. 1 Stereo Jack Adapter Assembly 3.271,1.75 4.031,1.938 0.76,0.188 10 false (Shielded) 5.667,0.542 6.125,0.74 0.458,0.198 10 false 13 5.677,1.323 6.135,1.521 0.458,0.198 10 false 14 5.677,2.104 6.135,2.302 0.458,0.198 10 false 12 5.906,0.635 6.365,0.833 0.458,0.198 10 false VV+ 5.906,1.438 6.365,1.635 0.458,0.198 10 false VV- 5.906,2.219 6.365,2.417 0.458,0.198 10 false SG 5.688,2.688 6.146,2.885 0.458,0.198 10 false F71 5.688,2.844 6.885,3.354 1.198,0.51 10 false Radio and Display Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the F71 radio and display receiver assembly connector.


b.

Disconnect the F74 No. 1 stereo jack adapter assembly connector.


c.
E277839
1.5,0.333 1.917,0.552 0.417,0.219 1.5,2.281 1.917,2.5 0.417,0.219 2.302,1.396 2.656,0.99 false 2.198,1.396 2.594,0.667 false 2.75,1.333 2.406,1.406 false 1.083,3.583 1.448,3.792 false 1.083,4.083 1.438,3.948 false 0.167,0.135 0.479,0.333 0.313,0.198 10 false *a 0.188,2.333 0.5,2.531 0.313,0.198 10 false *b 1.594,0.365 2.052,0.563 0.458,0.198 10 false F71 1.604,2.313 2.063,2.51 0.458,0.198 10 false F74 2.708,0.885 3.167,1.083 0.458,0.198 10 false VV+ 2.625,0.5 3.083,0.698 0.458,0.198 10 false SG 2.792,1.219 3.25,1.417 0.458,0.198 10 false VV- 0.792,3.417 1.25,3.615 0.458,0.198 10 false VV+ 0.833,4.083 1.292,4.281 0.458,0.198 10 false VV-
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F71-13 (VV+) - F74-6 (VV+) Always Below 1 Ω
F71-14 (VV-) - F74-11 (VV-) Always Below 1 Ω
F71-13 (VV+) - Body ground Always 10 kΩ or higher
F71-14 (VV-) - Body ground Always 10 kΩ or higher
F71-12 (SG) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR