If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck high (e.g. shorted to +B), the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B279A | Theft Deterrent System Communication Line High Fixation | Communication line (EFIO-IMI) between the ECM and transponder key ECU assembly is stuck high. | ·
Wire harness or connector ·
ECM ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Turn the ignition switch to ON and wait 6 seconds. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started (initial ignition occurs and engine cranks, then ignition stops) | Engine cannot be started |
| DTC No. | Data List and Active Test |
|---|---|
| B279A | - |
If the transponder key ECU assembly or ECM is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Perform "DTC Output Confirmation Operation" procedure.
Check for DTCs.
DTC B279A is not output.
| Result | Proceed to |
|---|---|
| B279A is not output | A |
| B279A is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Check that the connectors are properly connected to the ECM and transponder key ECU assembly.
Connectors are properly connected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F66 transponder key ECU assembly connector.
Disconnect the A43 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F66-13 (EFIO) - A43-28 (IMI)*1 | Always | Below 1 Ω |
| F66-13 (EFIO) - A43-31 (IMI)*2 | Always | Below 1 Ω |
| A43-28 (IMI) or F66-13 (EFIO) - Body ground*1 | Always | 10 kΩ or higher |
| A73-31 (IMI) or F66-13 (EFIO) - Body ground*2 | Always | 10 kΩ or higher |
*1: for 1AR-FE
*2: for 2GR-FE
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the transponder key ECU assembly with a new one.
Refer to Service Bulletin.
Key ID code registration is necessary when replacing the transponder key ECU assembly, refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Perform "DTC Output Confirmation Operation" procedure.
Check for DTCs.
DTC B279A is not output.
| Result | Proceed to |
|---|---|
| B279A is not output | A |
| B279A is output | B |
A
B
for 1AR-FE: Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>ECM>REMOVAL
for 2GR-FE: Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>ECM>REMOVAL