Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM(w/o Smart Entry and Start System) › 2013.12–2016.11
RM3160E _58 Vehicle Interior _019706 THEFT DETERRENT / KEYLESS ENTRY _0097123 IMMOBILISER SYSTEM(w/o Smart Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  B279C  Theft Deterrent System Presence Detection  


DESCRIPTION

If an ECM that is incompatible with the immobiliser system is installed, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B279C Theft Deterrent System Presence Detection An ECM that is incompatible with immobiliser system is installed. ECM
DTC Output Confirmation Operation:

Check for DTCs.



Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started -

Related Data List and Active Test
DTC No. Data List and Active Test
B279C -

CAUTION / NOTICE / HINT

NOTICE:
·

If the ECM is replaced, refer to Service Bulletin.

·

After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 234

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Perform "DTC Output Confirmation Operation" procedure.


b.

Check for DTCs.

Powertrain > Engine > Trouble Codes
50001 234
OK:

DTC B279C is not output.



Result:
Result Proceed to
DTC B279C is not output A
DTC B279C is output B



A

B

3.REPLACE ECM
3.REPLACE ECM
a.

Temporarily replace the ECM with a new one.

for 1AR-FE: Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>ECM>REMOVAL

for 2GR-FE: Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>ECM>REMOVAL


Result:
Proceed to
NEXT



NEXT

END