Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY
RM3160E _57 Power Source / Network _019703 POWER DISTRIBUTION _0100675 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 47220D 3.DISCONNECT BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (for LHD)

a.
E286286

Disconnect the connector.


b.

Remove the bolt.


c.
E286287

Disengage the 2 guides and disconnect the brake master cylinder reservoir assembly as shown in the illustration.


Hide 47233 4.REMOVE RESERVOIR BRACKET (for LHD)

a.
E286289

Remove the 2 bolts and reservoir bracket.


Hide 82662A 5.REMOVE NO. 1 RELAY BLOCK COVER

a.
E286292E01
2.969,1.667 3.125,1.865 0.156,0.198 10 true A 0.438,0.531 0.594,0.729 0.156,0.198 10 true B

Disengage the claw (A) as shown in the illustration.


b.

Disengage the 2 claws (B) and remove the No. 1 relay block cover.


c.
E286295

Disengage the 4 claws and remove the No. 1 relay block cover.


Hide 82644 6.REMOVE SEMICONDUCTOR PWR INTEGRATION ECU

a.
E286298

Disengage the 2 claws.


b.

Pull up the semiconductor pwr integration ECU as shown in the illustration.

NOTICE:

When pulling the semiconductor pwr integration ECU, take care not to damage it.



c.
E286301

Disconnect the 5 connectors and remove the semiconductor pwr integration ECU.

NOTICE:

When pulling the semiconductor pwr integration ECU, take care not to damage it.