Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH
RM3160E _59 Vehicle Exterior _019722 LIGHTING (EXT) _0100995 HEADLIGHT LEVELING SWITCH G

LIGHTING (EXT)  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 84152 1.INSPECT HEADLIGHT LEVELING SWITCH

a.

Voltage Check

i.
E290842
1,1.75 1.417,1.333 false 2.25,1.719 1.885,1.333 false 2.49,1.479 2.042,1.24 false 1.802,1.74 1.729,1.333 false 1.323,1.74 1.563,1.333 false 0.313,0.302 0.74,0.667 0.427,0.365 10 false *a 2.292,1.635 2.719,2 0.427,0.365 10 false T 0.948,1.75 1.375,2.115 0.427,0.365 10 false E 2.531,1.427 2.958,1.792 0.427,0.365 10 false B 1.229,1.74 1.656,2.104 0.427,0.365 10 false ILL- 1.74,1.75 2.167,2.115 0.427,0.365 10 false ILL+
*a Component without harness connected
(Headlight Leveling Switch)


Connect a positive (+) lead from the battery to terminal 1 (B) and a negative (-) lead to terminal 5 (E).


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
2 (T) - 5 (E) 0 10.44 to 11.16 V
1 8.52 to 9.24 V
2 6.60 to 7.32 V
3 4.68 to 5.40 V
4 2.76 to 3.48 V
5 0.84 to 1.56 V


HINT:

Battery voltage is 12 V.


If the result is not as specified, replace the headlight leveling switch.



b.

Illumination Inspection

i.

Apply battery voltage to the headlight leveling switch and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
Illuminates


If the result is not as specified, replace the headlight leveling switch.