Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3160E _59 Vehicle Exterior _019722 LIGHTING (EXT) _0100996 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89408D 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

a.

Connect 3 dry cell batteries (1.5 V) in series.

NOTICE:

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.


E289011
0.354,2.375 0.813,2.219 false 4.958,2.271 5.417,2.115 false 6.385,2.271 5.885,2.115 false 5.646,2.635 5.646,2.125 false 4.917,1.073 5.344,1.448 0.427,0.375 10 false *a 0.875,1.688 1.302,2.063 0.427,0.375 10 false *g 0.927,2.646 1.354,3.021 0.427,0.375 10 false *e 0.479,2.052 0.906,2.427 0.427,0.375 10 false *c 0.229,2.302 0.656,2.677 0.427,0.375 10 false *f 0.948,3.219 1.375,3.594 0.427,0.375 10 false *d 0.802,1.156 1.229,1.531 0.427,0.375 10 false *b 6.438,2.229 6.865,2.604 0.427,0.375 10 false SHG 5.5,2.656 5.927,3.031 0.427,0.375 10 false SHRR 4.635,2.208 5.063,2.583 0.427,0.375 10 false SHB
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly)
*b Low
*c Standard Position *d High
*e -25.9° *f 3.5°
*g +24.6° - -



b.

Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).


c.

Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRR) - 1 (SHG) +45° (High) 4.5 V
2 (SHRR) - 1 (SHG) 0° (Standard position) 2.25 V
2 (SHRR) - 1 (SHG) -45° (Low) 0.5 V


If the result is not as specified, replace the rear height control sensor sub-assembly.