1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE REAR WHEEL LH
89408D
4.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
Disconnect the connector.
Remove the bolt.
Disengage the guide.
|
Bolt |
|
Nut |
Remove the bolt and 2 nuts.
Disengage the guide to remove the rear height control sensor sub-assembly LH.
Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.