Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM › 2013.12–2016.11
RM3160E _53 Suspension _019691 TIRE / WHEEL _0101106 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Inspect the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:
Tire Size Cold Tire Inflation Pressure
Front Rear
245/60R18
245/55R19
240 kPa (2.4 kgf/cm2, 35 psi) 240 kPa (2.4 kgf/cm2, 35 psi)



b.
C137874

Using a dial indicator, check the runout of the tires.

Maximum Tire Runout:

1.4 mm (0.0551 in.)



Hide 2. ROTATE TIRES

a.
C266026C01
0,0 0,0 false
V100135

Front


Rotate the tires as shown in the illustration.

Torque:
Axle Hub Nut : 103 N*m (1050 kgf*cm, 76 ft.*lbf)


Hide 3.INSPECT AND ADJUST WHEEL BALANCE

a.
C144018C01
2.052,3.667 2.281,3.823 0.229,0.156 10 false *a
*a 25 mm (0.984 in.)


Inspect and adjust the off-the-car balance.

Maximum Imbalance:

8.0 g (0.0176 lb)


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the adhesive surface of the balance weight.

·

Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.

·

Push the balance weight with your finger to securely adhere it to the desired position.

·

Do not reuse balance weights.



HINT:

Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.