Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM MAIN SWITCH
RM3160E _59 Vehicle Exterior _019722 LIGHTING (EXT) _0101120 AUTOMATIC HIGH BEAM MAIN SWITCH G

LIGHTING (EXT)  AUTOMATIC HIGH BEAM MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84153 1.INSPECT AUTO HIGH BEAM SWITCH

a.
E136319
1.813,1.479 2.177,1.844 false 1.583,1.479 1.281,1.844 false 2.031,1.344 2.396,0.979 false 1.427,1.333 1.063,0.969 false 2.448,0.854 2.552,1.01 0.104,0.156 10 false E 0.906,0.792 1.271,0.979 0.365,0.188 10 false +B 1.063,1.875 1.469,2.073 0.406,0.198 10 false ILL+ 2.125,1.875 2.531,2.083 0.406,0.208 10 false ILL- 0.208,0.167 0.406,0.323 0.198,0.156 10 false *a
*a Component without harness connected
(Auto High Beam Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (+B) - 1 (E) Auto high beam switch off 10 kΩ or higher
Auto high beam switch on Below 1 Ω


If the result is not as specified, replace the auto high beam switch.


b.

Illumination Inspection

i.

Apply battery voltage to the auto high beam switch and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the auto high beam switch.