Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type)
RM3160E _56 Audio / Visual / Telematics _019701 NAVIGATION / MULTI INFO DISPLAY _0101135 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Vehicle Speed Signal Circuit between Radio Receiver and Extension Module  


DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM

E261261E35
1.24,1.115 1.854,1.313 0.615,0.198 10 false SPD0 5.531,1.115 6.146,1.313 0.615,0.198 10 false SPD 1.719,0.99 2.333,1.188 0.615,0.198 10 false 2 5.323,1 5.646,1.198 0.323,0.198 10 false 5 0.5,1.948 1.115,2.146 0.615,0.198 10 false n3 0.51,2.104 2.292,2.469 1.781,0.365 10 false Radio and Display Receiver Assembly 5.427,2 6.042,2.198 0.615,0.198 10 false n4 5.427,2.156 6.417,2.396 0.99,0.24 10 false Navigation ECU 3.396,1.26 4.01,1.458 0.615,0.198 10 false *1 3.01,2.156 4.854,2.427 1.844,0.271 10 false *1: No. 1 Navigation Wire

PROCEDURE

1.CHECK NO. 1 NAVIGATION WIRE
a.

Disconnect the n3 radio and display receiver assembly connector.


b.

Disconnect the n4 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
n3-2 (SPD0) - n4-5 (SPD) Always Below 1 Ω
n3-2 (SPD0) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG