Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type) › 2013.12–2016.11
RM3160E _56 Audio / Visual / Telematics _019701 NAVIGATION / MULTI INFO DISPLAY _0101135 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Reverse Signal Circuit  


DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the BACK UP LP relay.

WIRING DIAGRAM

E276668
5.219,2.896 6.417,3.365 1.198,0.469 10 false Radio and Display Receiver Assembly 5.219,2.74 6.448,2.906 1.229,0.167 10 false F71 2.344,2.667 3.896,2.854 1.552,0.188 10 false from BKUP LP Fuse 2.344,2.323 5.063,2.5 2.719,0.177 10 false from Park/Neutral Position Switch Assembly 2.458,0.5 3.573,0.698 1.115,0.198 10 false to Back-up Lights 2.156,1.865 3.219,2.104 1.063,0.24 10 false BACK UP LP 2.865,1.042 3.938,1.24 1.073,0.198 10 false 5 5.208,1.042 5.344,1.24 0.135,0.198 10 false 2 5.375,1.156 5.781,1.344 0.406,0.188 10 false REV

PROCEDURE

1.CHECK BACK-UP LIGHT
a.

Move the shift lever to R and check if the back-up lights come on.

OK:

The back-up lights come on.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
a.

Disconnect the F71 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F71-2 (REV) - Body ground Engine switch on (IG)
Shift lever in R
11 to 14 V
F71-2 (REV) - Body ground Engine switch on (IG)
Shift lever in any position other than R
Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR