Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM3160E _59 Vehicle Exterior _019721 WIPER / WASHER _0101301 WASHER MOTOR G

WIPER / WASHER  WASHER MOTOR  INSPECTION  


PROCEDURE

Hide 85310C 1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E239390
0.094,0.104 0.323,0.302 0.229,0.198 10 *a
*a Component without harness connected
(Windshield Washer Motor and Pump Assembly)


for Front Washer:

i.

Remove the washer jar.


ii.

Disconnect the windshield washer motor and pump assembly connector.

HINT:

This check should be performed with the windshield washer motor and pump assembly installed on the washer jar.



iii.

Fill the washer jar with washer fluid.


iv.

Connect a battery positive (+) lead to terminal 1 of the windshield washer motor and pump assembly, and a negative (-) lead to terminal 2.


v.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.


If the result is not as specified, replace the windshield washer motor and pump assembly.



b.
E239390
0.094,0.104 0.323,0.302 0.229,0.198 10 *a
*a Component without harness connected
(Windshield Washer Motor and Pump Assembly)


for Rear Washer:

i.

Remove the washer jar.


ii.

Disconnect the windshield washer motor and pump assembly connector.

HINT:

This check should be performed with the windshield washer motor and pump assembly installed on the washer jar.



iii.

Fill the washer jar with washer fluid.


iv.

Connect a battery positive (+) lead to terminal 2 of the windshield washer motor and pump assembly, and a negative (-) lead to terminal 1.


v.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.


If the result is not as specified, replace the windshield washer motor and pump assembly.