Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR › 2013.12–2015.11
RM3160E _59 Vehicle Exterior _019721 WIPER / WASHER _0101308 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
E267170C08
1.479,0.344 1.885,0.615 0.406,0.271 1.948,1.354 2.448,1.656 false 1.583,1.354 1.073,1.688 false 0.135,0.156 0.448,0.354 0.313,0.198 10 false *a 0.948,1.719 1.26,1.917 0.313,0.198 10 false ES 2.396,1.677 2.76,1.875 0.365,0.198 10 false SIG 1.573,0.385 2.031,0.583 0.458,0.198 10 false S13
*a Front view of wire harness connector
(to Rain Sensor)


Disconnect the S13 rain sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
S13-4 (SIG) - S13-2 (ES) Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
S13-2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


d.
E257042C05
0.087,0.071 0.320,0.259 0.232,0.188 10 *a 1.126,0.265 1.586,0.417 0.460,0.152 10 ES 2.294,0.265 2.808,0.417 0.513,0.152 10 MPX 1.821,0.97 1.314,0.448 false 1.97,0.97 2.476,0.448 false
*a Component with harness connected
(Rain Sensor)


Reconnect the S13 rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.

Check for pulses.

OK:
Tester Connection Condition Specified Condition
1 (MPX) - 2 (ES) Ignition switch ON Pulse generation


If the result is not as specified, replace the rain sensor.