Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM3160E _59 Vehicle Exterior _019722 LIGHTING (EXT) _0103403 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Door Mirror Foot Light Circuit  


DESCRIPTION

The outer mirror control ECU assembly receives signals from the main body ECU (multiplex network body ECU) to control the door mirror foot lights.

WIRING DIAGRAM

E287912E05
4.052,1.229 5.708,1.729 1.656,0.5 10 false Main Body ECU (Multiplex Network Body ECU) 4.052,1.052 4.333,1.292 0.281,0.24 10 false F18 2.281,2.948 3.698,3.458 1.417,0.51 10 false Outer Rear View Mirror Assembly LH 2.302,4.667 3.719,5.177 1.417,0.51 10 false Outer Rear View Mirror Assembly RH 4.135,3.094 5.375,3.51 1.24,0.417 10 false Outer Mirror Control ECU Assembly LH 4.115,4.823 5.354,5.24 1.24,0.417 10 false Outer Mirror Control ECU Assembly RH 0.563,5.292 2.979,5.719 2.417,0.427 10 false : CAN Communication Line 4.844,0.458 5.458,0.656 0.615,0.198 10 false CANP 4.844,0.844 5.458,1.042 0.615,0.198 10 false CANN 5.333,0.292 5.948,0.49 0.615,0.198 10 false 9 5.323,0.688 5.938,0.885 0.615,0.198 10 false 10 3.365,2.156 3.979,2.354 0.615,0.198 10 false MLP+ 3.656,2.563 4.271,2.76 0.615,0.198 10 false - 3.354,3.885 3.969,4.083 0.615,0.198 10 false MLP+ 3.646,4.292 4.26,4.49 0.615,0.198 10 false - 3.875,2.271 4.49,2.469 0.615,0.198 10 false z10 3.875,2.656 4.49,2.854 0.615,0.198 10 false z10 3.906,4 4.521,4.198 0.615,0.198 10 false z9 3.917,4.385 4.531,4.583 0.615,0.198 10 false z9 4.229,2.281 4.844,2.479 0.615,0.198 10 false MLP+ 4.24,2.677 4.854,2.875 0.615,0.198 10 false - 4.24,3.99 4.854,4.188 0.615,0.198 10 false MLP+ 4.24,4.385 4.854,4.583 0.615,0.198 10 false - 4.833,2.26 5.448,2.458 0.615,0.198 10 false CANP 4.844,4.01 5.458,4.208 0.615,0.198 10 false CANP 4.823,2.688 5.438,2.885 0.615,0.198 10 false CANN 4.833,4.406 5.448,4.604 0.615,0.198 10 false CANN 5.438,2.094 6.052,2.292 0.615,0.198 10 false 9 5.438,2.479 6.052,2.677 0.615,0.198 10 false 8 5.427,3.823 6.042,4.021 0.615,0.198 10 false 9 5.438,4.219 6.052,4.417 0.615,0.198 10 false 8 3.906,2.49 4.521,2.688 0.615,0.198 10 false 12 3.906,4.219 4.521,4.417 0.615,0.198 10 false 12 3.948,3.823 4.563,4.021 0.615,0.198 10 false 2 3.958,2.094 4.573,2.292 0.615,0.198 10 false 2 5.417,2.271 6.031,2.469 0.615,0.198 10 false I2 5.417,2.667 6.031,2.865 0.615,0.198 10 false I2 5.385,4 6,4.198 0.615,0.198 10 false H2 5.396,4.396 6.01,4.594 0.615,0.198 10 false H2

CAUTION / NOTICE / HINT

NOTICE:
·

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.*

*: w/ Smart Entry and Start System


·

As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.*

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION

*: for LHD




PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Mirror L or Mirror R / Active Test.


e.

Check that the door mirror foot lights illuminate.

Body Electrical > Mirror L > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Foot Light Door mirror foot light LH ON/OFF -
Body Electrical > Mirror R > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Foot Light Door mirror foot light RH ON/OFF -
Body Electrical > Mirror L > Active Test
Tester Display
Foot Light
50004 225 1
Body Electrical > Mirror R > Active Test
Tester Display
Foot Light
50004 224 1
OK:

Door mirror foot lights illuminate.



Result:
Result Proceed to
OK A
NG (Door mirror foot light LH does not illuminate) B
NG (Door mirror foot light RH does not illuminate) C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

2.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH

C

3.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH
2.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH
a.

Remove the outer rear view mirror assembly LH.

Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL


b.
E182505C06
1.385,1.375 0.75,1.01 false 1.688,1.583 1.844,1.833 false 0.115,0.083 0.313,0.26 0.198,0.177 10 false *a 0.271,0.906 0.781,1.094 0.51,0.188 10 false MLP+ 1.844,1.865 1.979,2.063 0.135,0.198 10 false -
*a Component without harness connected
(Outer Rear View Mirror Assembly LH)


Connect a positive (+) lead from the battery to terminal 2 (MLP+) and a negative (-) lead to terminal 12 (-).


c.

Check that the door mirror foot light LH illuminates.

OK:

Door mirror foot light illuminates.



Result:
Proceed to
OK
NG



OK

REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY LH

NG

REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH

3.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH
a.

Remove the outer rear view mirror assembly RH.

Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL


b.
E182505C06
1.385,1.375 0.75,1.01 false 1.688,1.583 1.844,1.833 false 0.115,0.083 0.313,0.26 0.198,0.177 10 false *a 0.271,0.906 0.781,1.094 0.51,0.188 10 false MLP+ 1.844,1.865 1.979,2.063 0.135,0.198 10 false -
*a Component without harness connected
(Outer Rear View Mirror Assembly RH)


Connect a positive (+) lead from the battery to terminal 2 (MLP+) and a negative (-) lead to terminal 12 (-).


c.

Check that the door mirror foot light RH illuminates.

OK:

Door mirror foot light illuminates.



Result:
Proceed to
OK
NG



OK

REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY RH

NG

REPLACE OUTER REAR VIEW MIRROR ASSEMBLY RH