INSPECT INTERIOR LIGHT CONTROL OPERATION
Perform this inspection with the customize parameters at the default settings.
The interior light control illuminates the lights below.
Engine Switch Illumination*1
Transponder Key Coil (Ignition Key Cylinder Light)*2
Map Light Assembly
Spot Light Assembly LH and RH (for Front Side)
Spot Light Assembly LH and RH (for Rear Side)
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System
The operations and conditions of this control are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | Any door is opened when all doors are closed. |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met, the interior lights illuminate for 15 seconds, and then fade out:
·
The key enters any actuation area around the doors when the ignition switch is off and all doors are closed.*1, *2 ·
Any door is unlocked when the ignition switch is off with all doors closed and locked. ·
The ignition switch is turned from ON or ACC to off when all doors are closed. ·
All doors are closed after any door is opened when the ignition switch is off. |
| Fade out immediately | When any of the following conditions is met, the interior lights fade out immediately:
·
The ignition switch is turned from off to ACC when all doors are closed. ·
All doors are locked when the ignition switch is off, all doors are closed and any door is unlocked. ·
All doors are locked again when all doors are already closed and locked. |
*1: When the lights are on, if the key leaves all of the actuation areas around the doors, after approximately 3 seconds, the lights fade out.
*2: w/ Smart Entry and Start System
INSPECT AMBIENT LIGHT CONTROL OPERATION (w/ Ambient Light)
Perform this inspection with the customize parameters at the default settings.
The ambient light control illuminates the following lights.
Front Door Trim Board Sub-assembly LH and RH (Front Door Ambient Light LH and RH)
Rear Door Trim Board Sub-assembly LH and RH (Rear Door Ambient Light LH and RH)
No. 1 Interior Illumination Light Assembly (Driver Side and Passenger Side)
The operations and conditions of this control are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | When either of the following conditions is met, the lights fade in:
·
Any door is opened when all doors are closed. ·
The ignition switch is turned from off to ON. |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met, the lights illuminate for 15 seconds and then fade out:
·
Any door is unlocked when the ignition switch is off, all doors are closed and all doors are locked. ·
The ignition switch is turned from ON or ACC to off when all doors are closed. ·
All doors are closed when any door is opened and the ignition switch is off. |
| Fade out immediately | All doors are locked when the ignition switch is off. |
| Dim | The ignition switch is ON and the shift lever is moved out of P. |
INSPECT BATTERY SAVING CONTROL OPERATION
Perform this inspection with the customize parameters at the default settings.
The lights controlled by the battery saving control are as follows:
Engine Switch Illumination*1
Transponder Key Coil (Ignition Key Cylinder Light)*2
Map Light Assembly
Spot Light Assembly LH and RH (for Front Side)
Spot Light Assembly LH and RH (for Rear Side)
No. 1 Room Light Assembly
Visor Assembly LH and RH (Vanity Light LH and RH)
Courtesy Light Assembly LH and RH
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System
The operation and conditions of this control are described below.
| Operation | Condition |
|---|---|
| Battery saving | When 20 minutes elapse after the ignition switch is turned from ON or ACC to off and the lights that operate remain on, the lights are turned off.
|
*: w/ Smart Entry and Start System