Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT
RM3160E _58 Vehicle Interior _019707 LIGHTING (INT) _0103720 PERSONAL LIGHT G

LIGHTING (INT)  PERSONAL LIGHT  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT MAP LIGHT ASSEMBLY

a.
B361012
0.75,1.833 0.844,1.115 false 2.604,0.979 2.885,0.344 false 0.635,0.969 0.729,0.375 false 1.042,0.958 1.417,0.385 false 1.479,1.833 1.281,1.104 false 2.74,1.844 2.604,1.344 false 0.125,0.115 0.438,0.271 0.313,0.156 10 false *a 2.802,0.167 3.417,0.365 0.615,0.198 10 false GND 0.698,1.875 1.313,2.073 0.615,0.198 10 false B 1.333,0.177 1.948,0.375 0.615,0.198 10 false CTY 1.438,1.875 2.052,2.073 0.615,0.198 10 false ILL 0.542,0.177 1.156,0.375 0.615,0.198 10 false RRMP 2.656,1.875 3.271,2.073 0.615,0.198 10 false LILL
*a Component without harness connected
(Map Light Assembly)


Inspect the personal lights.

i.

Apply battery voltage to the connector and check that each personal light comes on.

OK:
Measurement Condition Condition Specified Condition
Battery positive (+) → 10 (B)
Battery negative (-) → 1 (GND)
Interior light ON/OFF switch off and personal light switch LH on Personal light LH comes on
Interior light ON/OFF switch off and personal light switch RH on Personal light RH comes on
Interior light ON/OFF switch on and personal light switch LH and RH off Personal light LH and RH come on
Interior light ON/OFF switch off and personal light switch LH and RH off Personal light LH and RH do not come on
Battery positive (+) → 10 (B)
Battery negative (-) → 9 (CTY)
Interior light DOOR switch on and personal light switch LH and RH off Personal light LH and RH come on
Interior light DOOR switch off and personal light switch LH and RH off Personal light LH and RH do not come on
Interior light DOOR switch off and personal light switch LH and RH on Personal light LH and RH do not come on


If the result is not as specified, replace the bulb or map light assembly.



b.

Inspect the switch illumination.

i.

Apply battery voltage to the connector and check that the switch illumination comes on.

OK:
Measurement Condition Condition Specified Condition
Battery positive (+) → 8 (ILL)
Battery negative (-) → 12 (LILL)
Always Switch illumination comes on


If the result is not as specified, replace the map light assembly.



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (GND) - 11 (RRMP) Personal light switch LH and RH off and interior light ON/OFF switch on Below 1 Ω
Personal light switch LH and RH off and interior light ON/OFF switch off 10 kΩ or higher
9 (CTY) - 11 (RRMP) Personal light switch LH and RH off and interior light DOOR switch on Below 1 Ω
Personal light switch LH and RH off and interior light DOOR switch off 10 kΩ or higher


If the result is not as specified, replace the map light assembly.