Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Navigation Receiver Type)
RM3160E _56 Audio / Visual / Telematics _019701 NAVIGATION / MULTI INFO DISPLAY _0104171 NAVIGATION SYSTEM(for Navigation Receiver Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Navigation Receiver Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the navigation receiver assembly.

WIRING DIAGRAM

E280465E12
4.958,2.063 6.885,2.313 1.927,0.25 10 false Navigation Receiver Assembly 4.958,1.906 5.448,2.115 0.49,0.208 10 false F116 2.656,1.448 3.188,1.656 0.531,0.208 10 false A58 2.656,1.625 4.031,2.021 1.375,0.396 10 false Parking Brake Switch Assembly 3.698,1.01 4.188,1.448 0.49,0.438 10 false 1 5.146,1.01 5.635,1.448 0.49,0.438 10 false 15 5.406,1.125 5.896,1.563 0.49,0.438 10 false PKB

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.


Result:
Proceed to
OK
NG




OK

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)
a.

Disconnect the F116 navigation receiver assembly connector.


b.

Disconnect the A58 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F116-15 (PKB) - A58-1 Always Below 1 Ω
F116-15 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR