Home › Vehicle Interior › MIRROR (INT) › INNER REAR VIEW MIRROR › 2013.12–2016.11
RM3160E _58 Vehicle Interior _019709 MIRROR (INT) _0104191 INNER REAR VIEW MIRROR D

MIRROR (INT)  INNER REAR VIEW MIRROR  CALIBRATION  


SELECT COMPASS DISPLAY MODE


a.
B341229C01
2.625,1.5 2.625,1 2.625,1 2.833,1 false 1.698,2.104 1.698,2.688 1.698,2.688 1.448,2.688 false 2.896,0.917 3.208,1.073 0.313,0.156 10 false *a 1.26,2.604 1.573,2.76 0.313,0.156 10 false *b
*a Compass Display
*b AUTO Switch


The AUTO switch allows selection of the compass display.



PERFORM CALIBRATION


a.

The compass indicates the direction that the vehicle is heading by detecting the direction and strength of the earth's magnetic field (magnetic north).


b.

Because each vehicle has its own magnetic field, calibration should be performed. The calibration function is used to compensate for the residual magnetism of the vehicle.



WHEN COMPASS IS MAGNETIZED


a.

The compass or vehicle may become magnetized while the vehicle is being shipped. As a result, it is necessary to perform calibration for the compass before the vehicle is delivered to the customer. If calibration cannot be performed successfully (calibration cannot be completed despite driving in calibration mode several times), it may be caused by excessive magnetization of the vehicle. Demagnetize the vehicle using a demagnetizer and perform calibration again.



SET COMPASS


B347028E05
0.635,0.708 2.188,1.083 1.552,0.375 10 false AUTO switch pressed for 6 seconds 1.896,1.771 3.458,2.115 1.563,0.344 10 false AUTO switch pressed for 18 seconds 4.458,0.417 6.146,0.615 1.688,0.198 10 false Normal mode 4.469,0.813 5.896,1.083 1.427,0.271 10 false Ignition switch ON 4.458,1.5 5.99,1.823 1.531,0.323 10 false Compass display on/off 4.469,2.542 5.698,2.802 1.229,0.26 10 false Calibration mode 4.458,3.729 6.146,3.927 1.688,0.198 10 false Normal mode 5.417,3.094 6.74,3.458 1.323,0.365 10 false No switches pressed for several seconds


CALIBRATION MODE


a.

When the compass is in normal mode, pressing the AUTO switch for 18 seconds will activate calibration mode.


b.
B365115

Drive the vehicle in a circle at a speed of 8 km/h (5 mph) or less.


c.

After driving in a circle 1 to 3 times, the direction (N, NE, E, SE, S, SW, W or NW) will be displayed on the compass display. This indicates that calibration has finished.

HINT:

After calibration is performed, it is not necessary to repeat the calibration procedure unless the magnetic field of the vehicle changes drastically. If the magnetic field changes drastically, the compass display will indicate "C".