Home › Engine / Hybrid System › 1AR-FE EMISSION CONTROL › PURGE VALVE
RM3160E _51 Engine / Hybrid System _019674 1AR-FE EMISSION CONTROL _0104494 PURGE VALVE G

1AR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 17650 1.INSPECT PURGE VALVE (PURGE VSV)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge valve (purge VSV).


b.
A320232
2.677,0.813 2.865,0.344 2.865,0.344 3.094,0.344 false 2.063,1.01 2.615,1.865 2.615,1.865 2.844,1.865 false 2.927,1.781 3.24,1.938 0.313,0.156 10 false *a 3.156,0.271 3.417,0.469 0.26,0.198 10 false *b 1.125,1.75 1.438,1.906 0.313,0.156 10 false *c
*a Port (E)
*b Port (F)
*c Air


Apply battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).

Standard:
Condition Specified Condition
Battery voltage applied between terminals 1 and 2 Air flows from port (F)
Battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the purge valve (purge VSV).