Home › Engine / Hybrid System › 2GR-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019665 2GR-FE EMISSION CONTROL _0104497 EMISSION CONTROL SYSTEM G

2GR-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL CUT OPERATION

a.

Start the engine.


b.

Warm up the engine.


c.

Increase the engine speed to approximately 3500 rpm.


d.
A192826C03
0.823,0.583 1.094,0.583 1.094,0.583 1.927,1.646 true 2.719,1.438 2.333,0.563 2.333,0.563 1.969,0.563 true 0.604,0.49 0.813,0.792 0.208,0.302 10 true *1 1.729,0.49 1.938,0.792 0.208,0.302 10 true *a
*1 Fuel Injector Assembly
*a Sound Scope


Use a sound scope to check for fuel injector assembly operating sounds.


e.

When the accelerator pedal is fully released, check that fuel injector assembly operating sounds stop momentarily and then resume.

Standard:
Item Specified Condition
Fuel cut-off engine speed 2500 rpm or higher
Fuel injection restart engine speed 1400 rpm


If the result is not as specified, check the fuel injector assembly, wire harness and ECM.


Hide 2.VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS

a.

Check the hoses and gaskets for scratches, cracks or air/oil leaks from the connecting parts.

HINT:

If the hoses or gaskets are damaged or any of the connections are loose, they may cause an engine stall or malfunction.



Hide 3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Connect the GTS to the DLC3.


b.
A320240

Slide the clip and disconnect the fuel vapor feed hose assembly from the purge valve (purge VSV).


c.

Start the engine.


d.

Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for Evap Control.

Powertrain > Engine > Active Test
Tester Display
Activate the VSV for Evap Control
50004 234 6

e.

Check that vacuum occurs at the purge valve (purge VSV) port.


f.

If vacuum does not occur, check the following items.

·

Purge valve (purge VSV)

·

Clogging in the fuel vapor feed hose assembly that connects the intake manifold and purge valve (purge VSV)

·


g.

Exit Active Test mode and reconnect the fuel vapor feed hose assembly.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.


h.

Enter the following menus: Powertrain / Engine / Data List / EVAP (Purge) VSV.

Powertrain > Engine > Data List
Tester Display
EVAP (Purge) VSV
50003 234 31

i.

Warm up the engine and drive the vehicle.


j.

Confirm that the purge valve (purge VSV) opens.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.