1.INSPECT ENGINE SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (SS1) - 6 (AGND) | Not pushed | 10 kΩ or higher |
| 1 (SS2) - 6 (AGND) | ||
| 5 (SS1) - 6 (AGND) | Pushed | Below 1 Ω |
| 1 (SS2) - 6 (AGND) |
If the result is not as specified, replace the engine switch.
Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch indicator light.
If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
If the voltage is too low, the engine switch indicator light will not illuminate.
| *a | Indicator Light | - | - |
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND) |
Illuminates |
If the result is not as specified, replace the engine switch.