Home › Engine / Hybrid System › 2GR-FE STARTING › ENGINE SWITCH › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019669 2GR-FE STARTING _0105673 ENGINE SWITCH G

2GR-FE STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE SWITCH

a.

Measure the resistance according to the value(s) in the table below.

A256118C06
5.385,1.208 5.615,1.208 false 5.375,0.896 5.51,0.406 5.51,0.406 5.573,0.406 false 4.354,0.885 4.125,0.292 4.125,0.292 4.031,0.292 false 3.74,0.208 4.052,0.49 0.313,0.281 10 SS1 5.625,0.333 5.938,0.625 0.313,0.292 10 SS2 5.646,1.146 6.219,1.469 0.573,0.323 10 AGND

Standard Resistance:
Tester Connection Condition Specified Condition
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND)
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND)


If the result is not as specified, replace the engine switch.


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch indicator light.

NOTICE:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

·

If the voltage is too low, the engine switch indicator light will not illuminate.



A256118C13
1.865,0.833 1.406,0.5 1.406,0.5 1.271,0.5 false 4.594,1.302 4.146,1.479 4.146,1.479 4.031,1.479 false 5.365,1.229 5.615,1.229 false 3.667,1.396 4.031,1.729 0.365,0.333 10 false SWIL 5.667,1.156 6.375,1.563 0.708,0.406 10 false AGND 1.094,0.427 1.406,0.583 0.313,0.156 10 false *a
*a Indicator Light - -


Standard:
Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


If the result is not as specified, replace the engine switch.