Home › Vehicle Exterior › HORN › RELAY
RM3160E _59 Vehicle Exterior _019723 HORN _0105902 RELAY G

HORN  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86530 1.INSPECT HORN RELAY

a.
E276394
0.792,1 0.885,0.438 0.885,0.438 1.021,0.438 false 1.135,0.948 1.344,0.448 1.344,0.448 1.5,0.448 false 1.115,1.333 1.302,1.75 1.302,1.75 1.438,1.75 false 0.573,1.26 0.635,1.75 0.635,1.75 0.802,1.75 false 0.104,0.083 0.417,0.24 0.313,0.156 10 false *a 1.073,0.354 1.229,0.521 0.156,0.167 10 false 5 1.552,0.365 1.708,0.531 0.156,0.167 10 false 1 1.49,1.656 1.646,1.823 0.156,0.167 10 false 2 0.854,1.656 1.01,1.823 0.156,0.167 10 false 3
*a Component without harness connected
(HORN Relay)


Remove the HORN relay.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the HORN relay.