Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY
RM3160E _59 Vehicle Exterior _019718 SLIDING ROOF / CONVERTIBLE _0106112 SLIDING ROOF SWITCH ASSEMBLY G

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)

a.
B351356
0.521,2.885 0.833,3.083 0.313,0.198 10 false *a
*a Component without harness connected
(Sliding Roof Switch (Map Light Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 - 1 UP switch is pressed Below 1 Ω
6 - 1 UP switch is not pressed 10 kΩ or higher
5 - 1 DOWN switch is pressed Below 1 Ω
5 - 1 DOWN switch is not pressed 10 kΩ or higher
17 - 1 OPEN switch is pressed Below 1 Ω
17 - 1 OPEN switch is not pressed 10 kΩ or higher
16 - 1 CLOSE switch is pressed Below 1 Ω
16 - 1 CLOSE switch is not pressed 10 kΩ or higher


If the result is not as specified, replace the sliding roof switch (map light assembly).