Home › Vehicle Exterior › WINDOW / GLASS › QUARTER WINDOW GLASS
RM3160E _59 Vehicle Exterior _019717 WINDOW / GLASS _0106124 QUARTER WINDOW GLASS A

WINDOW / GLASS  QUARTER WINDOW GLASS  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE ROOF HEADLINING ASSEMBLY

Hide 62720A 2.REMOVE QUARTER WINDOW ASSEMBLY

a.
B361308C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear roof side rail garnish LH as shown in the illustration.


b.
B361309

for LH side:

i.

Remove the bolt.


ii.

Disengage the clamp and disconnect the wire harness.



c.
B361310

for RH side:

i.

Remove the bolt.


ii.

Disengage the 2 clamps and disconnect the wire harness.



d.
B361311C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape to the area around the installation position of the quarter window assembly on the vehicle body to prevent it from being scratched.


e.
B361312C01
1.021,1.281 0.344,0.646 0.344,0.646 1.219,0.313 false 2.313,1.75 3.042,1.51 true 0.406,1.604 0.698,1.49 false 0.125,0.573 0.448,0.813 0.323,0.24 10 false *1 0.208,1.542 0.521,1.698 0.313,0.156 10 false *a 3.104,1.438 3.354,1.698 0.25,0.26 10 false *1
*1 Clip
*a Piano Wire


Pass a piano wire between the vehicle body and quarter window assembly from the interior.

NOTICE:

Do not pull the piano wire in a vertical direction, but pull it in a horizontal direction.



f.

Tie both wire ends to wooden blocks or similar objects that can serve as handles.


g.

Cut off the adhesive by pulling the piano wire around the quarter window assembly.

NOTICE:

When separating the quarter window assembly, be careful not to damage the paint or interior and exterior ornaments.



h.
B361313

Using suction cups, disengage the 3 clips and remove the quarter window assembly.

NOTICE:
·

Be careful not to drop the quarter window assembly.

·

Be sure to replace the quarter window assembly with a new one.




Hide 3.CLEAN VEHICLE BODY

a.
B361314C01
1.156,0.781 0.792,0.563 false 1.208,0.708 1.521,0.865 0.313,0.156 10 false *a 2.76,1.927 2.917,2.125 0.156,0.198 10 false a
*a Vehicle Body
V100155

Adhesive


Clean and shape the contact surfaces of the vehicle body.

Standard Dimension:
Area Dimension
a 1.0 mm (0.0394 in.) or more


i.

Using a knife, cut away excess adhesive on the contact surfaces of the vehicle body as shown in the illustration.

NOTICE:

Be careful not to damage the vehicle body.


HINT:

Leave approximately 1.0 mm (0.0394 in.) of adhesive on the vehicle body.




b.

Clean the contact surfaces of the vehicle body with a piece of cloth saturated with non-residue solvent.

HINT:

Even if all the adhesive has been removed, clean the vehicle body.