Home › Vehicle Exterior › WINDOW / GLASS › BACK WINDOW LOCK
RM3160E _59 Vehicle Exterior _019717 WINDOW / GLASS _0106125 BACK WINDOW LOCK G

WINDOW / GLASS  BACK WINDOW LOCK  INSPECTION  


PROCEDURE

Hide 69370E 1.INSPECT BACK WINDOW LOCK ASSEMBLY

a.

Check operation of the back window lock motor.

i.

Move the back window lock to the lock position.

B351340
2.51,1.292 2.823,1.49 0.313,0.198 10 false *a 3.844,0.417 4.156,0.615 0.313,0.198 10 false *b 5.646,0.427 5.958,0.625 0.313,0.198 10 false *c
*a Component without harness connected
(Back Window Lock Assembly)
*b Unlatched
*c Locked - -



ii.

Apply battery voltage to the back window lock motor and check the operation of the back window lock motor.

OK:
Connection Result
Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2
Unlatches


If the result is not as specified, replace the back window lock assembly.



b.

Check operation of the courtesy switch.

i.

Measure the resistance according to the value(s) in the table below.

B351340
2.51,1.292 2.823,1.49 0.313,0.198 10 false *a 3.844,0.417 4.156,0.615 0.313,0.198 10 false *b 5.646,0.427 5.958,0.625 0.313,0.198 10 false *c
*a Component without harness connected
(Back Window Lock Assembly)
*b Unlatched
*c Locked - -


Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Locked 10 kΩ or higher
1 - 2 Unlatched Below 1 Ω


If the result is not as specified, replace the back window lock assembly.