Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH
RM3160E _59 Vehicle Exterior _019717 WINDOW / GLASS _0104323 POWER WINDOW MASTER SWITCH G

WINDOW / GLASS  POWER WINDOW MASTER SWITCH  INSPECTION  


PROCEDURE

Hide 84820 1.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Models with Jam Protection Function on 4 Windows)

a.
B351352C01
0.396,1.938 0.708,2.135 0.313,0.198 10 false *a
*a Component without harness connected
(Power Window Regulator Master Switch Assembly)


Check that the LEDs illuminate.

i.

Apply battery voltage to the power window regulator master switch assembly and check that the LEDs illuminate.

OK:
Battery Connection Specified Condition
Battery positive (+) → 3
Battery negative (-) → 13
LEDs illuminate


If the result is not as specified, replace the power window regulator master switch assembly.



Hide 84820 2.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Models with Jam Protection Function on Front Door Windows)

a.
B351353C01
0.479,1.833 0.792,2.031 0.313,0.198 10 false *a
*a Component without harness connected
(Power Window Regulator Master Switch Assembly)


Check the switch function.

i.

Turn the window lock switch off and operate the switches on the power window regulator master switch assembly.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Driver Side Switch
Tester Connection Condition Specified Condition
1 - 4 Auto up Below 1 Ω
1 - 5 Auto down Below 1 Ω


Standard Resistance:
Rear LH Side Switch
Tester Connection Condition Specified Condition
1 - 15 Up Below 1 Ω
1 - 12 Off Below 1 Ω
1 - 15 Off Below 1 Ω
1 - 12 Down Below 1 Ω


Standard Resistance:
Rear RH Side Switch
Tester Connection Condition Specified Condition
1 - 16 Up Below 1 Ω
1 - 10 Off Below 1 Ω
1 - 16 Off Below 1 Ω
1 - 10 Down Below 1 Ω


If the result is not as specified, replace the power window regulator master switch assembly.



b.
B351353C01
0.479,1.833 0.792,2.031 0.313,0.198 10 false *a
*a Component without harness connected
(Power Window Regulator Master Switch Assembly)


Check that the LED illuminates.

i.

Apply battery voltage to the power window regulator master switch assembly and check that the LED illuminates.

OK:
Battery Connection Specified Condition
Battery positive (+) → 8
Battery negative (-) → 11
LED illuminates


If the result is not as specified, replace the power window regulator master switch assembly.