84810
1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Check the switch function.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 - 7 | Auto up or manual up position | Below 1 Ω |
| 4 - 7 | Auto down or manual down position | Below 1 Ω |
| 7 - 8 | Auto up or auto down position | Below 1 Ω |
| 4 - 5 | Off | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator switch assembly.
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Check that the LED illuminates.
Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.
| Battery Connection | Specified Condition |
|---|---|
| Battery positive (+) → 3
Battery negative (-) → 1 |
LED illuminates |
If the result is not as specified, replace the power window regulator switch assembly.