Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0106374 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1290  Steering Angle Sensor Zero Point Malfunction  


DESCRIPTION

The skid control ECU (brake actuator assembly) acquires steering angle sensor zero point every time the ignition switch is turned to ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The skid control ECU (brake actuator assembly) also stores the previous zero point.

If front wheel alignment or the steering wheel position is adjusted without disconnecting the negative battery terminal, or if yaw rate and acceleration sensor zero point is not acquired after the adjustments have been completed, the skid control ECU (brake actuator assembly) detects the difference between the previous zero point and newly acquired zero point and stores this DTC to indicate a poor adjustment.

The warning operation for the steering angle sensor zero point malfunction will be canceled by turning the ignition switch off.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1290 Steering Angle Sensor Zero Point Malfunction The newly acquired steering angle sensor zero point vastly differs from the previous one.
·

Yaw rate and acceleration sensor zero point calibration incomplete

·

Poor adjustment of the center position of the steering wheel

·

Poor adjustment of front wheel alignment



PROCEDURE

1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
a.

Perform zero point calibration of the yaw rate and acceleration sensor.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION

Chassis > ABS/VSC/TRC > Utility
Tester Display
Reset Memory
50005 105 138
Chassis > ABS/VSC/TRC > Utility
Tester Display
Test Mode
50005 105 166
HINT:
·

When the stored zero point of the yaw rate and acceleration sensor is cleared, steering angle sensor zero point will also be cleared.

·

If the zero point and output value of the yaw rate and acceleration sensor (airbag sensor assembly) and the output value of the speed sensors are not normal, steering angle sensor zero point cannot be acquired normally even if the vehicle is driven straight ahead at 35 km/h (22 mph) or more.




Result:
Proceed to
NEXT



NEXT

2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION
2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION
a.

Turn the ignition switch off.


b.

Start the engine.


c.

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.


d.

Check that the center position of the steering wheel is correctly set while driving straight ahead.

HINT:

If front wheel alignment and steering position are adjusted as a result of the steering wheel being off-center, acquire yaw rate and acceleration sensor zero point again after adjusting front wheel alignment and steering position again.


OK:

The steering wheel is centered correctly.



Result:
Proceed to
OK
NG



OK

END

NG

ADJUST FRONT WHEEL ALIGNMENT OR STEERING POSITION