Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › RELAY › 2013.12–2016.11
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0106376 RELAY G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 88263P 1.INSPECT STOP LIGHT CONTROL RELAY

a.
C223784C13
2.719,1.417 2.719,0.865 2.719,0.865 2.76,0.865 true 2.427,1.906 2.427,1.635 2.427,1.635 1.99,1.635 true 2.281,2.542 2.281,2.833 2.281,2.833 2.229,2.833 true 2.573,2.552 2.573,3.021 2.573,3.021 2.5,3.021 true 2.833,2.542 2.833,3.021 2.833,3.021 2.875,3.021 true 0.281,0.25 0.531,0.448 0.25,0.198 10 false *1 1.885,1.563 2.083,1.76 0.198,0.198 10 false 5 2.896,2.938 3.094,3.146 0.198,0.208 10 false 1 2.125,2.76 2.333,2.99 0.208,0.229 10 false 2 2.792,0.781 2.979,0.979 0.188,0.198 10 false 3 2.406,2.948 2.604,3.146 0.198,0.198 10 false 4
*1 Stop Light Control Relay (STOP LP Relay)


Remove the stop light control relay (STOP LP relay).


b.

Check both the relay case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Voltage is not applied between terminals 1 and 2 Below 1 Ω
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 4 Voltage is applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the stop light control relay (STOP LP relay).