Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106849 CAMSHAFT OIL CONTROL VALVE G

1AR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Turn the A/C switch on.


e.

Inspect the camshaft timing oil control valve assembly (for intake side).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Linear (Bank1).

Powertrain > Engine > Active Test
Tester Display
Control the VVT Linear (Bank1)
50004 234 32

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly using the GTS.

Standard Condition:
GTS Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

If the result is not as specified, allow the engine to cool (engine coolant temperature of 50°C (122°F) or less) and perform the Active Test again.

·

DTCs related to the VVT system may be stored due to Active Test operation, but this does not indicate a malfunction.



If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.



f.

Inspect the camshaft timing oil control valve assembly (for exhaust side).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Exhaust Linear (Bank1).

Powertrain > Engine > Active Test
Tester Display
Control the VVT Exhaust Linear (Bank1)
50004 234 87

ii.

Check the engine speed while operating the camshaft timing oil control valve assembly using the GTS.

Standard Condition:
GTS Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

If the result is not as specified, allow the engine to cool (engine coolant temperature of 50°C (122°F) or less) and perform the Active Test again.

·

DTCs related to the VVT system may be stored due to Active Test operation, but this does not indicate a malfunction.



If the operation is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.