Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › THROTTLE BODY
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106850 THROTTLE BODY G

1AR-FE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the throttle control motor operating sound.

i.

Turn the ignition switch to ON.


ii.

When depressing the accelerator pedal, check the operating sound of the throttle control motor. Make sure that no friction noise is emitted from the throttle control motor.

If any friction noise exists, replace the throttle body with motor assembly.



b.

Check the throttle position sensor.

i.

Connect the GTS to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 234 12

v.

Fully depress the accelerator pedal. When the throttle valve is fully open, check that the Throttle Sensor Position value is within specification.

Standard Throttle Valve Opening Percentage:
Tester Display Specified Condition
Throttle Sensor Position 60% or higher


NOTICE:
·

When checking the throttle valve opening percentage, the shift lever should be in P or N.

·

Fully depress the accelerator pedal.



If the percentage is less than 60%, check the throttle body with motor assembly, wire harness and ECM.