Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2013.12–2015.11
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106855 CRANKSHAFT POSITION SENSOR A

1AR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A192239
1.24,1.969 1.594,1.969 1.594,1.969 1.76,1.563 false 1.063,1.865 1.375,2.021 0.313,0.156 10 false *a
*a Adhesive


Apply adhesive to 2 or 3 threads of the bolt for the crankshaft position sensor.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



b.
A246907C08
1.677,0.958 2.052,0.5 false 2.094,0.396 2.323,0.594 0.229,0.198 10 false *a
*a O-ring


Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


c.

Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.




d.

Connect the crankshaft position sensor connector.


Hide 53736 3.INSTALL FRONT FENDER APRON SEAL RH