Home › Engine / Hybrid System › 1AR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM3160E _51 Engine / Hybrid System _019671 1AR-FE ENGINE CONTROL _0106857 ENGINE COOLANT TEMPERATURE SENSOR A

1AR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.

Install a new gasket to the engine coolant temperature sensor.


b.

Using a 19 mm union nut wrench, install the engine coolant temperature sensor to the cylinder head sub-assembly.

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:
·

If the engine coolant temperature sensor has been struck or dropped, replace it.

·

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




c.

Connect the engine coolant temperature sensor connector.


d.

Install the heater bracket to the cylinder head sub-assembly with the bolt.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


e.

Engage the heater hose to the heater bracket.


Hide 2.INSTALL AIR CLEANER ASSEMBLY

Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 6.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION